Looking after your print.

Every shirt is pressed by hand in Teesside, in small batches. The print is tough, but heat and friction are what wear it out. A few habits keep it sharp.

Washing

  • Wash it inside out at 30°C.
  • No bleach — not chlorine, not oxygen. It takes the print off before the cotton gives up.
  • Skip the fabric conditioner. It softens the glue that holds the print.
  • Tumble dry on low, inside out. Hanging it is gentler still.
  • Iron on the reverse, never straight onto the print.
  • No dry cleaning.

The one habit that matters

Turn every printed shirt inside out before it goes in the wash, and again before it goes in the dryer. Friction is what cracks a print over time, and this puts the shirt between the print and the drum.

First wash

The print is fully cured when it comes off the press, so it starts out a little stiff. One wash and it softens up. That's normal, not a fault.

Not sure on size?

Every design comes in S to 5XL. Here's how to measure.

Who made it

Curiosity Cavern Ltd is the manufacturer of the decorated garment. Company no. 17475452, registered in England & Wales. The blank comes from the supplier; the print, the pressing and the packing are ours.

The label at the neck is the supplier's, and it carries the fibre content. It has to be there when the shirt reaches you. That's a legal requirement, so it isn't ours to remove. It's a tear-out, so take it out if you'd rather not have it, though leaving it in makes a batch easier to trace.